Can Tempered Glass Be Removed and Installed Again

Download Article

Download Article

Tempered glass is impact-resistant and ofttimes used to cover delicate surfaces such as telephone screens. If your glass screen shatters, you can lift the tempered glass screen protector to uncover an undamaged surface beneath information technology. Tempered drinking glass is ordinarily held by an adhesive, which should exist heated first to loosen it. Then, slowly peel away the thin canvas of drinking glass to remove information technology and supercede it.

1. 

   1

   Heat the glass with a hair dryer on a low setting for 15 seconds. The rut loosens the agglutinative backside the glass, making it easier to remove. Still, tempered drinking glass should be heated briefly and only with low heat to avoid damaging whatever components behind it. Go the glass squeamish and toasty simply not hot to the impact.^[1]

   • If a hair dryer isn't available, you can attempt another rut source. Leaving it virtually a hot stove, open flame, furnace, or in a steamy bathroom may encourage the adhesive to cook.

2. 

   2

   Lift ane corner of the drinking glass with your fingernails. Dig downwardly with your fingernails until yous observe the bottom of the tempered drinking glass. You should be able to barely go 1 corner away from the surface underneath information technology. Avoid rushing, yet. Elevator the corner carefully, but don't try to pare off the rest of the drinking glass.

   • Try all the corners. Yous can usually observe 1 that lifts away from what is underneath it. If none of them come up up, heat the glass a second time to loosen the gum.
   • If the glass is cracked near 1 of the corners, choose a different corner to prevent if from breaking into many smaller pieces.

   Advertising

3. 

   3

   Movement your fingers underneath the glass. As you pare it off, the sparse layer of tempered glass will dissever from the surface underneath it. The edges of the drinking glass will begin coming up beginning. Slide your hand underneath these edges to support the glass, preventing it from fragmenting. Do this even if you are removed a small piece of cracked glass to prevent it from breaking further.^[two]

   • Tempered drinking glass is very thin, so it is prone to breaking. Cleaved glass leaves a lot of individual fragments you have to peel abroad by hand. The only way to preclude this is to be very cautious.

4. 

   4

   Peel the tempered drinking glass back slowly and evenly. Skin the glass off in as much of an even layer as possible. Slide your hands along the glass' loose edges to avoid lifting upwardly 1 side more than another. Keep doing this until the piece of glass is gone, and then repeat the process for whatever remaining pieces.^[3]

   • Any small, splintered pieces of tempered drinking glass tin can exist picked upwards the aforementioned way. Although they tin be a little obnoxious, they will be easier to peel back than the principal piece.

   Advertizing

1. 

   1

   Warm upwardly the drinking glass for 15 seconds with low heat. Apply a device such every bit a hair dryer, if you take ane. Oestrus the glass until information technology feels warm all over but not hot to the touch. This should loosen the gum holding the glass in place.^[4]

   • While you might exist able to warm upwardly the glass by holding it shut to a friction match or lighter, yous probably won't be able to become the entire sheet to a consistent temperature and may damage the components below information technology. You can try heating up one corner to brand information technology easier to lift.

2. 

   two

   Utilise the pointed end of a toothpick to pry upwardly i corner of the glass. It's of import to make sure the toothpick is angled correctly and then it doesn't damage whatever is beneath the tempered drinking glass. Choose i corner and hold the toothpick flat beside information technology. Slide the tip of the toothpick underneath the slice of glass, so pull information technology up until you are able to slide your fingers underneath information technology.^[v]

   • Avoid angling a pointy toothpick downwards. If you're removing tempered drinking glass from a phone, for instance, yous will end upward scratching the screen beneath it.
   • If you lot don't have a toothpick available, yous may be able to pry upwardly the drinking glass using another precipitous particular like a fork or with your fingers.

3. 

   3

   Elevator the edges of the drinking glass with your fingers. Be very careful, especially if the glass is cracked. Tempered drinking glass is delicate and decumbent to breaking into bunches of smaller pieces. Slide your finger along the outer edge of the piece of glass you lot wish to remove. Elevator it up enough to fit the edge of a credit card underneath it.^[vi]

   • This works for cracked or smaller pieces of glass as well as whole pieces, but avert pulling the glass up also far in one management. Lift each piece at an even rate to prevent it from turning into a jigsaw of shards.

4. 

   4

   Slide a credit carte du jour underneath the drinking glass to skin it off. Position the card underneath the glass corner you lifted upwardly. Slowly push the carte du jour frontwards. Information technology should dissever the tempered drinking glass from the surface underneath it. Lift the piece of drinking glass up evenly until you are able to remove it, and then repeat this with any remaining fragments.^[seven]

   • Make certain yous use a hard, plastic card, such equally a credit card, library carte, or ID.
   • Y'all can often use a credit card to remove the entire slice of glass. If the piece of glass is larger than the length of the card, such as on an iPad, use your fingers to help lift the glass at an even rate.

   Advertising

1. 

   ane

   Oestrus the drinking glass for xv seconds until its adhesive is loosened. A pilus dryer on a low setting or another similar object makes for a good, safe oestrus source. Get the drinking glass warm but don't overheat it. It shouldn't burn your fingers when y'all touch it.^[8]

2. 

   two

   Roll a piece of duct record around 2 of your fingers. Duct tape seems to have an unlimited number of uses, and so it's hardly surprising you can apply it to take off a tough piece of glass. Wrap the tape tightly around your fingers. Brand sure the gluey part of the tape faces outwards.^[9]

   • Doing this with your index and middle fingers may be the easiest way, only you tin can use other fingers if yous experience comfortable doing so.

3. 

   3

   Press the record to a corner of the glass. Choose a corner of the glass to work on. Any corner should do as long as there are no cracks near it. For cracked pieces, select an edge you tin accomplish with the tape. Proceed pressing the tape down until the glass sticks to it.

   • If you can't get a corner to stick, try some other corner. Sometimes the corners tin can exist stubborn considering the glue underneath them hasn't loosened enough.
   • If you're having problem picking up a corner, heat the glass again. You may wish to cull a corner and focus the heat on it to ensure the adhesive weakens.

4. 

   iv

   Roll the tape slowly towards the reverse end of the glass. Enhance your fingers, then move them towards the other terminate of the glass. The piece of glass should come with you. Be cautious, making sure it separates from the surface underneath it at an even rate. Once yous are able to remove the piece of glass, apply the tape on any remaining pieces.

   • Sometimes the glass will splinter considering one side came up faster than some other side. This will leave you with some smaller shards you can remove with your fingers or with the tape.

   Ad

Add New Question

• Question

  Is information technology prophylactic to take off thick tempered glass that has a pocket-size crack at the pinnacle, or should I just go to a specialist to take it off?

  

  Unless you've got a lot of experience doing this, it is better if a specialist comes so y'all don't get injure.

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Ad

• Consider replacing any tempered glass you remove. You can buy kits with new glass that prevents screens from scratches and other cruddy damage.

• Ever heat the glass first if possible. The solidified glue underneath tempered drinking glass can make removing information technology a frustrating procedure.

• Tempered glass is delicate when information technology is lifted off of a surface. While fragmented glass isn't a big deal, removing the trivial shards can be annoying. Elevator the glass evenly equally best you lot can to prevent this.

• After removing the glass, check over the surface to brand sure you lot didn't leave anything behind. Make clean off the surface with warm h2o and a microfiber fabric to prepare it for a new piece of glass.

Thanks for submitting a tip for review!

Ad

Things You lot'll Need

• Pilus dryer or culling heat source

• Hair dryer or alternative oestrus source
• Toothpick
• Credit carte

• Hair dryer or alternative heat source
• Duct tape

About This Article

Cheers to all authors for creating a folio that has been read 189,073 times.

Is this commodity upwardly to engagement?

smithfress1948.blogspot.com

Source: https://www.wikihow.com/Remove-Tempered-Glass

Share this post